I bought an “open box” 4900 last week. All the tape was off but the ink carts were sealed in their original plastic baggies. I set up the printer and no print. Set up for manual feed, it is communicating with my mac, knows where to pull paper from, prints absolutely blank. The nozzle test says every single nozzle is clogged but how can they be clogged when it has never printed a thing???
Hello and thanks so much for that tip. I do not have a flush option in my set up menu. If I could reset it to factory settings I could do a charge cycle again, but I have not been able to figure out how to do a reset.
Hi Eric, I sent you an email. help me
Looking for OEM firmware for Epson 9900 can you help me
servprog.exe you mean?
I bought an “open box” 4900 last week. All the tape was off but the ink carts were sealed in their original plastic baggies. I set up the printer and no print. Set up for manual feed, it is communicating with my mac, knows where to pull paper from, prints absolutely blank. The nozzle test says every single nozzle is clogged but how can they be clogged when it has never printed a thing???
Try to flush the ink through the print head. look for that function in the setup menu of the printer. Good luck
Hello and thanks so much for that tip. I do not have a flush option in my set up menu. If I could reset it to factory settings I could do a charge cycle again, but I have not been able to figure out how to do a reset.
Thanks though! All help very much appreciated!